Competency Written Test A
Quiz
How can the Range Conducting Officer usually be recognised?
- He will usually be positioned on the far left of any firing point
- He is always in attendance in the Clubhouse during live firing
- He will usually wear a hi-vis vest and RCO identifiication
- He must wear a cap issued by the National Rifle Association
When must a range safety brief must be given to all shooters and range staff?
- Two days before the shoot
- On the day of the shoot prior to any rounds being fired
- One week before the shoot in writing
- Immediately after shooting has ceased
When a red flag is flying in the butts, this means that:
- No firing is allowed
- Firing is only allowed on the instruction of the RCO
- Firing must stop for 5 minutes to allow the butt party to get clear
- The range is subject to live firing and the flag warns any unauthorised person
If a shot is fired with the rifle muzzle elevated above 70 mils (approx. 4deg), the outcome will be:
- Safety is mantained because no-one can possibly be in the way
- The bullet will not hit the stop butt or be contained within the danger area
- The shot will not count for competition purposes
- The bullet will be contained within the cleared danger area
A 'mil' is:
- A building where wool is spun
- A flour production plant driven by wind or water
- A unit of measurement of angle
- An abbreviation of mother in law
What is the angle of rifle muzzle elevation (in mils) which must not be exceeded on gallery ranges when the rifle might be loaded?
- 60 mils
- 70 mils
- 80 mils
- 90 mils
What action should you take if the RCO orders you to "Show your rifle is clear"?
- Point your rifle at the stop butt and pull the trigger
- Open the bolt and allow him to inspect the empty chamber and magazine
- Remove the bolt and put your rifle in its carrying case
- Apply the safety catch and place the rifle on the ground beside you
How should your rifle be carried around the range when not on a firing point?
- Slung over your shoulder with bolt open and muzzle pointing upwards
- Slung over your shoulder with bolt closed and muzzle pointing downwards
- With the breech open and a breech flag, which must protrude into the chamber, clearly inserted, or with the bolt removed from the rifle
- In a carrying case with the bolt inserted and closed on an empty chamber
You are ordered to 'Unload' but when you open the bolt an unfired round remains in the chamber - you should:
- Keep the rifle pointed at the target, hold up your hand and report the fact to the RCO
- Point your rifle skywards and bang the butt firmly on the ground several times wih the bolt open to knock out the round
- Re-close the bolt, point the rifle at the target and fire off the jammed round
- Close the bolt hard to get the extractor to work properly
Due to a low scope mount, you cannot see into the chamber of your rifle, how do you check you rifle is empty after firing is finished?
- You work your bolt again. If nothing is extracted it must be clear
- You check your magazine visually and insert your little finger into the chamber to check it is empty too
- You close the bolt and fire again. If there is only a click the rifle must be empty
- You pass the rifle sideways to the next firer to check for you
If you are late and miss the Range Safety Brief how will you know what the correct loading procedures are on a particular range?
- Refer to an NRA Training manual
- Ask the person next to you
- You should have been given this information when you were notified of the shoot
- You cannot shoot until you have been given a range safety brief
After you have been ordered to "Load Magazines" you should place rounds into your magazine and:
- Chamber a round and fire quickly so as not to hold up proceedings
- Remain with the rifle pointing on target with bolt open and await further command
- Remain on target with bolt closed on a chambered round and await further command
- Have more rounds lying beside the rifle ready to load quickly as soon as the magazine has been emptied
When may you close the bolt on a round and commence firing? When the RCO orders:
- Load magazines
- Stop, Stop, Stop
- Fire
- Ready - in your own time go on
The RCO orders "Unload." While keeping your rifle pointing at the stop butt, you should:
- Open the bolt, press cartridges down into the magazine and close bolt on to an empty chamber
- Work the bolt rapidly back and forth 3 times before closing it and pulling the trigger on an empty chamber.
- Remove the magazine and open the bolt
- Check there is nothing in the chamber or magazine before closing the bolt and pulling trigger
What actions should you take if you squeeze the trigger and just hear a click?
- Raise and lower the bolt handle quickly to re-cock the acton before firing again.
- Remove the bolt from the rifle leaving the unfired round in the chamber
- Keep the rifle pointing at the target and raise a hand to attract the RCO's attention
- Open the bolt and eject the cartridge and examine the primer carefully
A misfired round is ejected and the cap shows no sign of having been struck - what might be the cause?
- The bolt handle was not fully down or the safety catch was applied when the trigger was squeezed
- The bolt was dirty/rusty preventing the firing pin from emerging fom the bolt face
- The firing pin was broken
- The misfire could have been caused by any of the reaons above
If the RCO shouts; 'Stop! Stop! Stop!' why might this have been done?
- It is time for the RCO's lunch break
- The RCO has identified a situation where shooting needs to stop immediately
- The RCO has seen a person arrive late and needs to give them a safety brief
- It has started to rain and the RCO needs to put on waterproofs before continuing
The aim of the "Stop! Stop! Stop!" drill is:
- To stop all firing activity quickly and safely because a dangerous situation has or is about to take place
- To make sure all firers are paying attention to the RCO's instructions
- To test the firer's knowledge of the range safety procedures before a danger occurs
- To clear the firing point as quickly as possible
When zeroing from 100 metres, your shots are not hitting the target. It is advisable to:
- Aim in turn at each corner of the target frame hoping that shots can be placed on the target
- Try shooting at 25 metres (if permitted) to significantly reduce the bullet spread over the target
- Ask someone else to zero for you
- Consider changing the rifle calibre
Before zeroing it is very important to check that:
- Scope lens covers have not been left at home
- That sunlight is not shining directly on the target
- That all your shooting equipment is maintained in good order
- All fittings and mountings are tight